19PC Master Set Front Wheel Hub Drive Bearing Removal Install Service Tool Kit

19PC Master Set Front Wheel Hub Drive Bearing Removal Install Service Tool Kit
19PC Master Set Front Wheel Hub Drive Bearing Removal Install Service Tool Kit
19PC Master Set Front Wheel Hub Drive Bearing Removal Install Service Tool Kit
19PC Master Set Front Wheel Hub Drive Bearing Removal Install Service Tool Kit
19PC Master Set Front Wheel Hub Drive Bearing Removal Install Service Tool Kit
19PC Master Set Front Wheel Hub Drive Bearing Removal Install Service Tool Kit
19PC Master Set Front Wheel Hub Drive Bearing Removal Install Service Tool Kit
19PC Master Set Front Wheel Hub Drive Bearing Removal Install Service Tool Kit
19PC Master Set Front Wheel Hub Drive Bearing Removal Install Service Tool Kit

19PC Master Set Front Wheel Hub Drive Bearing Removal Install Service Tool Kit
Comprehensive set for the removal and installation of front hub bearings. No dismantle of steering assembly needed.

2-3/16", 2-11/32", 2-7/16", 2-9/16, 2-19/32", 2-13/16", 2-7/8", 3-3/32", 3-5/16", 3. (3) M12x11.5, (3) M14x1.5mm. Most front wheel drive cars, vans & light trucks. These front wheel bearing adapters replace wheel bearings while keeping the steering knuckle and strut assembly in tact on the vehicle, eliminating the need for front end alignment once the work is done. Termine if the vehicle has a trapped rotor or a floating rotor.

Ssemble the tool components, and press out the worn bearing. Ghtly lubricate the new bearing, and position it for installation with the tool. Press the bearing into the spindle assembly until it bottoms. Sten the bearing retainer in place using the bearing retainer bolts. On Neon vehicles, install the snap ring in the knuckle.

Lightly oil the hub assembly, and install the hub. Attention: The bearing installer must be assembled with the flat side toward the bearing and the small diameter pilot on the side away from the bearing.

Semble the remaining vehicle components that were removed for bearing replacement: (1)lower ball joint to steering knuckle assembly brake rotor. (3)outer tie rod nut and tie rod. Everything needed for the job is included, providing the most effective removal and installation of wheel bearings. No hammering to remove and install the bearing. Avoids damaging the hub, bearing or other parts of the car.

Includes multiple sizes of drifts, can be used for various car models. Suits domestic and imported front wheel drive cars and light trucks.

1 x Steel Drifts : 38mm. 2 x Drift : 86mm, 91mm. 1 x Receiver Sleeve : 76mm. 9 x Adapter Drift: 55.5mm, 59mm, 62mm, 65mm, 66mm, 71.5mm, 73mm, 78mm, 84mm. 3 x Hub Screw : M12 x 1.5 mm. 3 x Hub Screw : M14 x 1.5 mm. This item is in the category "eBay Motors\Automotive Tools & Supplies\Hand Tools\Other Automotive Hand Tools". The seller is "huanke2020-1" and is located in this country: US. This item can be shipped to United States.
19PC Master Set Front Wheel Hub Drive Bearing Removal Install Service Tool Kit


Homepage    Archives    Contact Us    Privacy Policies    Terms of service